FUTABA 3PM - Page 25

26
Initial Set-Up
- Steering dual rate (DT3) check
At initial set-up, steering dual rate is assigned to grip
lever DT3 (upper) at the grip of the transmitter. Oper-
ate the DT3 lever and check if the D/R value displayed
on the screen changes. After checking D/R, set the
steering dual rate to 100%.
- Throttle ATL (DT4) check
At initial setting, throttle ATL is assigned to grip lever
DT4 (lower) at the grip of the transmitter. Operate the
DT4 lever and check if the ATL value displayed on the
screen changes. After checking ATL, set throttle ATL
to 100%.
Steering D/R
value
Throttle ATL
position
DT3
DT4