FUTABA GY701 - Edit Screen; Edit Screen Navigation

E
DIT
S
CREEN
E
DIT
S
CREEN
32
33
The edit mode is changed to Gyro basic, Gover-
nor basic, S.Bus basic mode by pushing the data+
or- key. These modes set the basic operation set-
ting for initial ight. Pushing the mode + or – key
for more than 1 second at the gyro or governor
screen, the editing mode is changed to the expert
mode, the precise setting can be done by this
mode. Pushing the mode+ or – key for 1 second
again, the editing menu is returned to basic menu.
The setting of the governor functions are skipped
at the gyro only mode or the gyro function are
skipped at the governor only mode as well.
Pushing the mode+ or – key at basic or expert
mode, the edit menu is scrolled and the parameter
can be set on the each menu.
During the home screen, the display is changed to
Max. revolution→Engine runtime→OLED dis-
play mode→LED display mode→Operation mode
by pushing the data+ or - key.
The below the diagram shows the edit sequence.
The instruction describes the Gyro+Governor
mode after.
Push DATA
+/– key
Push MODE
+/– key
Push MODE +/– key
for 1 second
Max. revolution
Home
screen
Engine runtime
OLED display mode
LED display mode
Operation mode
Gyro Basic
Gyro Expert
Governor Expert
S.Bus Basic
Governor Basic