Why does my Gainscha Label Maker skip labels when printing?
Skipping labels on your Gainscha Label Maker could be due to incorrect label size settings, so check if label size is setup correctly. The sensor sensitivity might not be set properly, so calibrate the sensor by Auto Gap or Manual Gap options. Also, the media sensor may be covered with dust, so clear the GAP/Black mark sensor with a blower.
What causes missing printing on the sides of labels with Gainscha GA-3406T?
Missing print on the sides of labels with your Gainscha Label Maker is caused by wrong label size setup. Set the correct label size.
What to do if my Gainscha GA-3406T is out of paper?
If your Gainscha Label Maker is out of paper, install new paper. If the issue persists, the paper installation path may be incorrect, so follow the steps for installing the paper to reinstall. Also, the gap or black mark sensor detection could be incorrect, so recalibrate the label sensor.
Why is the printing position of small labels incorrect on my Gainscha Label Maker?
Incorrect printing position of small labels on your Gainscha Label Maker can occur if the media sensor sensitivity is not set properly, so calibrate the sensor sensitivity again. Ensure the label size is correct. If using the software BarTender, set the vertical offset in the driver.
What to do if my Gainscha GA-3406T Label Maker is out of ribbon?
If your Gainscha Label Maker is out of ribbon, install a new ribbon. If the problem continues, the ribbon installation path may be incorrect, so follow the steps for installing the ribbon to reinstall.
General| Resolution | 203 DPI |
|---|---|
| Memory | 4MB Flash Memory / 8MB SDRAM |
| Interface | USB, Serial (RS-232), Ethernet |
| Print Method | Thermal transfer |
| Max. Print Width | 104 mm |
| Media Thickness | 0.06 mm - 0.25 mm |
| Processor | 32-bit RISC |
| Power Supply | AC 100-240V, 50/60Hz |
| Maximum Print Width | 104 mm |
| Label Thickness Range | 0.06 mm - 0.25 mm |
| Printing Technology | Thermal transfer |
| Media Type | Label roll |
| Media Width | 25.4 mm (1") ~ 115 mm (4.5") |
| Label Width Range | 25.4 mm (1") ~ 115 mm (4.5") |
Details the specifications and features of the standard printer models.
Provides step-by-step instructions for setting up the printer on a flat surface.
Guides users through the process of installing the printer driver software on their computer.
Instructions on how to start and navigate the Printer Utility software interface.
Guides on how to configure general printer settings via the utility.
Information and settings for the RFID module.
How to set up the related functions of the RFID module.
How to perform read/write operations and manage RFID tags.
Step-by-step guide to designing labels using BarTender software.
How to configure RFID options within the BarTender software.
Steps to install the RFID driver for the printer.
How to set and manage access passwords for RFID tags.
How to set and manage kill passwords for RFID tags.
Steps for upgrading the printer's firmware through its normal status.
Lists common printer problems and their solutions for troubleshooting.
To Next Page
