AMP-43740 (-D3740)
Description
The AMP-43740 is a sinusoidally commutated, 16 bit PWM amplifier. The AMP-43740 can be configured for the
motors below with just a few commands.
• Brushless Motors
• Brushed Motors
WARNING
Do not “hot swap” the motor power or supply voltage power input connections. If the amplifier is
enabled when the motor connector is connected or disconnected, damage to the amplifier can
occur. Galil recommends powering the controller and amplifier down before changing the connector,
and breaking the AC side of the power supply connection in order to power down the amplifier.
Chapter 5 Integrated Components ▫ 30 DMC-40x0 UL Installation Manual
To Next Page
Loading...
Need help?
General
