Gamma Vacuum SPCe - Serial Parameters Menu (Serial); Figure 22: Mode; Figure 23: Address; Figure 24: Handshaking

Figure 22. Mode
Address
This parameter is used to set the SPCe serial address. The default value is 5.
Figure 23. Address
Handshaking
This parameter is used to set serial handshaking. The default value is set to
disabled.
Figure 24. Handshaking
6.6. Serial parameters menu (Serial)
Figure 25. Serial menu
SW protocol
This parameter chooses the command set used for remote commands.
04/2021 - ©Gamma
Page 24900026_F
900026_F - Display menu