Gamma Vacuum SPCe - Figure 26: SW Protocol; Figure 27: Baud Rate; Figure 28: Parity

Figure 26. SW protocol
Baud rate (Baud)
This parameter is used to set the serial baud rate of the SPCe. The default
value is 115200.
Figure 27. Baud rate
Parity
This parameter is used to set the parity party check of the SPCe. The default
value is None.
Figure 28. Parity
Data bits
This parameter is used to set the serial data bits of the SPCe. The default
value is 8.
Data and stop bits
This parameter is used to set the stop bits of the SPCe. The default value is
1.
04/2021 - ©Gamma
Page 25900026_F
900026_F - Display menu