Gamma Vacuum SPCe - Configuration Menu (Config); Figure 33: Gateway Address; Figure 34: MAC Address; Figure 35: Configuration Menu

To Next Page

To Previous Page

Gateway

When DHCP is disabled, the user may change the SPCe Ethernet gateway

address.

Figure 33. Gateway address

MAC address (MAC)

This screen shows the controller’s MAC address.

Figure 34. MAC address

6.8. Conguration menu (Cong)

Figure 35. Conguration menu

Contrast

This function is used to adjust the contrast of the display. Use the arrow keys

to adjust the screen contrast.

Figure 36. Adjust display

Page 27900026_F

900026_F - Display menu

Main Page

Table of Contents3
Safety and Compliance7
Definition of Warnings and Cautions7
Safety Symbols8
Warnings8
Safety Notices9
General Information11
Approvals11
Unpacking the Controller12
Inspect for any Obvious Damage12
Check the Equipment Received12
Installation13
Required Items13
Installation Procedure13
Operation14
Front Panel14
High Voltage Operation (Quick Start)14
Figure 1: Front Panel14
Display Menu16
Display During Ion Pump Operation16
Figure 2: Display During Ion Pump Operation16
System Information Menu (Sys)17
Figure 3: Accessing Main Menu Settings17
Figure 4: System Information Menu (Sys)17
Figure 5: Pump Size17
Figure 6: Units18
Figure 7: Setpoint Function Config18
Figure 8: Setpoint18
High Voltage Output Menu (Output)19
Figure 9: Factor19
Figure 10: Output19
Figure 11: Voltage20
Figure 12: Current20
Figure 13: Foldback Pressure20
Supply Menu (Supply)21
Figure 14: System Output Supply21
Figure 15: Supply Menu21
Figure 16: Arc Processing21
Figure 17: Auto HV22
Figure 18: HV Enable22
Communications Mode (Comm)23
Figure 19: Battery Mode23
Figure 20: Communication Mode23
Figure 21: RS Protocol23
Serial Parameters Menu (Serial)24
Figure 22: Mode24
Figure 23: Address24
Figure 24: Handshaking24
Figure 25: Serial Menu24
Figure 26: SW Protocol25
Figure 27: Baud Rate25
Figure 28: Parity25
Ethernet Parameters Menu (Ethnt)26
Figure 29: Data and Stop Bits26
Figure 30: Ethernet Parameter Menu26
Figure 31: DHCP and IP Address26
Figure 32: Subnet Mask26
Configuration Menu (Config)27
Figure 33: Gateway Address27
Figure 34: MAC Address27
Figure 35: Configuration Menu27
Figure 36: Adjust Display27
Diagnostics Menu (Diag)28
Figure 37: Pump Name28
Figure 38: Adjust LCD Timeout28
Figure 39: Diagnostic Menu28
Figure 40: Calibrate Supply29
Figure 41: Emission Analysis29
Figure 42: High Pot29
Spc30
Figure 43: Supply Jump Start30
Figure 44: SPC30
Figure 45: Technician Features30
Figure 46: Events31
Figure 47: Update Firmware31
Figure 48: DIGITEL Spce31
Display Messages32
Back Panel Operation34
Remote Hardware Option (J1)34
Figure 49: Back Panel View34
Figure 50: Remote Hardware34
Figure 51: Pressure Output35
Figure 52: Current Output36
Power Supplies37
Serial (J3) and Ethernet (J2) Operation38
Ethernet Connector38
Serial Connector38
Figure 53: Ethernet Connector38
Figure 54: Serial Connector38
Standard39
Cabling39
Command Packet Structure39
Decoding the Command Packet41
Response Packet42
RS 232/422/485 General Commands43
CRC Checksum Example49
Serial Command Examples50
Warranty and Service52
Service52
Cleaning Procedure52
Service Requests52
Direct Support52
Warranty53
General Terms53
Warranty Claims54
Returning Material54
Return Procedure54
Required Documentation54
Disposal56

Gamma Vacuum SPCe - Configuration Menu (Config); Figure 33: Gateway Address; Figure 34: MAC Address; Figure 35: Configuration Menu

Table of Contents

Other manuals for Gamma Vacuum SPCe

Related product manuals