Console module »DP-HR-U-CON-Fiber-MC4«
133 · Computer and console modules (DP-HR-U)
Console module
»DP-HR-U-CON-Fiber-MC4«
With DP-HR-U-CON-Fiber-MC4 console modules, you can connect a dual-monitor con-
sole (four DisplayPort monitors, keyboard, mouse and audio devices) to a digital
matrix switch of the ControlCenter-Compact or ControlCenter-Digital series.
At the installed console, matrix switch users can access a computer module to operate
the connected computer.
The data stream of the connected USB devices is transmitted to the active computer
module with up to 16 Mbit/s (
DVI-U-CPU, DP-U-CPU, DP-HR-U-CPU and VGA-U-CPU series
only).
When using the console to access a multi-monitor computer with four graphics out-
puts, the separate images of the graphics outputs are displayed on the console moni-
tors.
When accessing the system with a computer module with only one graphics input,
only the first monitor shows an image.
NOTE:
This console module can be connected to a compatible fiber port of
ControlCenter-Compact matrix switches or ControlCenter-Digital matrix switches
(requires CCD-I/O 16-Card-Fiber).
IMPORTANT:
Both, the console module and the fiber ports are available as single-
mode variants or as multimode variants. Make sure that the port at the console module,
the fiber port and the optical fibers are compatible with each other.
NOTE:
Connecting a multi-monitor computer with four video outputs requires four
computer modules of the
DP-HR-U-CPU series or two computer modules of the DP-HR-
U-CPU-MC2
series.
In the web application, you can add the computer modules of the multi-monitor
computers to a channel groups More information about this topic is given in the
chapter Expanding the system through port grouping of the web application manual.
To Next Page
Loading...
