G&D DP-HR-U-CPU - Console Module DP-HR-U-CON-Fiber-MC2

Console module »DP-HR-U-CON-Fiber-MC2«
125 · Computer and console modules (DP-HR-U)
Console module
»DP-HR-U-CON-Fiber-MC2«
With DP-HR-U-CON-Fiber-MC2 console modules, you can connect a dual-monitor con-
sole (two DisplayPort monitors, keyboard, mouse and audio devices) to a digital
matrix switch of the ControlCenter-Compact or ControlCenter-Digital series.
At the installed console, matrix switch users can access a computer module to operate
the connected computer.
The data stream of the connected USB devices is transmitted to the active computer
module with up to 16 Mbit/s (
DVI-U-CPU, DP-U-CPU, DP-HR-U-CPU and VGA-U-CPU series
only).
When using the console to access a computer module DP-HR-U-CPU-MC2 connected to
a dual-head computer, the monitors display the separate images of the graphics out
-
puts.
When accessing a computer module with one graphics input only, only the first
monitor displays an image.
NOTE: This console module can be connected to a compatible fiber port of
ControlCenter-Compact matrix switches or ControlCenter-Digital matrix switches
(requires CCD-I/O 16-Card-Fiber).
IMPORTANT: Both, the console module and the fiber ports are available as single-
mode variants or as multimode variants. Make sure that the port at the console module,
the fiber port and the optical fibers are compatible with each other.
ADVICE: Instead of an MC2 computer module, you can also connect a dual-head
computer by using two separate computer modules
DP-HR-U-CPU.
In this case, add both computer modules in the web application to channel group.