Page 26 of 35 GTLE Error list GTLE Operating Manual
Message-
number
Sensor-/
actuator
Messagetext Reason Action
36 M4 Platform overload up
The current value when the motor ramp is moving
exceeds the set maximum value
Check whether the drive can be moved easily, if this is the case,
check the set limit value.
37 M4 Platform overload down
The current value when the motor ramp is moving
exceeds the set maximum value.
Check whether the drive can be moved easily, if this is the case,
check the set limit value.
38 -
Barrier noticed during platform lowering
(S14)
An obstacle was detected when lowering.
Remove the obstacle and acknowledge the error by driving in
the opposite direction for two seconds.
39 S25/S26 Platform drive both limit switch active
The two limit switches from the platform motor are
actuated at the same time (S25/S26).
Check if a limit switch is stuck.
Platform runtime error
Limit switch cannot be reached within the set time
Check platform motor limit switches or monitor run time settings
41 S14 Barrier noticed during lift move left (S14) An obstacle was detected when driving to the left.
Remove the obstacle and acknowledge the error by driving in
the opposite direction for two seconds.
42 S14 Barrier noticed during lift move right (S14)
An obstacle was detected when driving to the
Remove the obstacle and acknowledge the error by driving in
the opposite direction for two seconds
43 S10 Obstacle right (S10)
Side shutdown on the right side has triggered
(S10)
Check whether the side switch is pressed and remove the
obstacle
44 S10.1 Obstacle right (S10.1)
Side shutdown on the right side has triggered
Check whether the side switch is pressed and remove the
45 S11 Obstacle left (S11) Side shutdown on the left has triggered (S11)
Check whether the side switch is pressed and remove the
obstacle
46 S11.1 Obstacle left (S11.1) Side shut-off on the left has triggered (S11.1)
Check whether the side switch is pressed and remove the
47 S14.1 Top cover pressed (S14.1)
Contact switch S14.1 on the upper side of the lift
has triggered
Check if the contact switch is pressed and remove the obstacle
48 S14.1 Top cover pressed (S14.1)
Contact switch S14.1 on the upper side of the lift
Check if the contact switch is pressed and remove the obstacle.
To Next Page
Loading...