GARDASOFT RC1 Series - Setting up Switched Output; Setting up Pulsed Operation

RC1xx LED Lighting Controllers - User Manual
— 25 —
10.2.4 Setting up switched output
Press and hold SEL for 1 second and follow the keystrokes below:
CH1 is displayed. Press the SEL button.
Use the  and  buttons to select SOn
(other options displayed are SPu and SCo).
Press the SEL button.
bri is displayed. Press the SEL button.
Use the  and  buttons to select the
required brightness from 1% to 999%.
Press the SEL button.
Use the  and  buttons to set the
Trigger ag: F P is enabled, F-P is disabled.
Press the SEL button.
Use the  and  buttons to set the Error
Detect ag: F E is enabled, F-E is disabled.
Press the SEL button.
Switched output is set up.
10.2.5 Setting up pulsed operation
Press and hold SEL for 1 second and follow the keystrokes below:
CH1 is displayed. Press the SEL button.
Use the  and  buttons to select SPu
(other options displayed are SOn and
SCo). Press the SEL button.
bri is displayed. Press the SEL button.
Use the  and  buttons to select the
required brightness from 1% to 999%.
Press the SEL button.