GARDASOFT RC1 Series - Setting the Light Rating; Setting up Continuous Output

RC1xx LED Lighting Controllers - User Manual
— 24 —
10.2.2 Setting the light rating
Press and hold SEL for 1 second and follow the keystrokes below:
CH1 is displayed. Use the  and 
buttons to scroll to rAt.
Press the SEL button.
Use the  and  buttons to select the
method you require to set the rating of the
light: Cur for current and Vol for voltage.
Press the SEL button.
Use the  and  buttons to set the
current in Amps and the voltage in Volts.
Press the SEL button.
The light’s rating is set up.
10.2.3 Setting up continuous output
Press and hold SEL for 1 second and follow the keystrokes below:
CH1 is displayed. Press the SEL button.
Use the  and  buttons to select SCo
(other options displayed are SPu and
SOn). Press the SEL button.
bri is displayed. Press the SEL button.
Use the  and  buttons to select the
required brightness from 1% to 99%. Press
the SEL button.
Use the  and  buttons to set the Error
Detect ag: F E is enabled, F-E is disabled.
Press the SEL button.
Continuous output is set up.