RTxxx LEDlighting controllers - User Manual
maintain the target current. This will compensate for any inaccuracies
such as temperature drift in the controller.
If the output current is less than 100mA, the adjustments the feature
imposes can have a significant effect on the lighting brightness. If
some flickering is seen, it is recommended that the current adjust
feature is turned off.
Current adjust can be turned on and off from the web page interface
(see Section 11, Webpage configuration (RT220, RT420, RT820F)) or by
using the RE command (See Section 12, Command configuration).
7.7 Cold start
You can clear the RTxxx configuration to its default settings - this
clears the lighting ratings and sets all channels to 50% brightness
continuous operation. You can do this by sending the CL command
using Ethernet or serial connection.
— 29 —
To Next Page
Loading...
