RTxxx LEDlighting controllers - User Manual
1 Getting started
This user manual describes the setting up and operation of the RTxxx
range of LED lighting controllers.
Read Section Safety (or Section 3, Sicherheit, or Section 4, Sécurité) and
Section 13.1, Specification, and check the RTxx controller fulfils your
requirements.
Mount the RTxxx as described in Section 5, Mounting the RTxxx and
connect the RTxxx up to a power supply as described in Section 6,
Connections. The RT200 shows a two alternating lines on it's display to
indicate it is working properly.
Read Section 8, Lighting setup. Enter the current or voltage rating of
the lights and then connect the lights. Set up the RTxxx for the desired
operation as described in the configuration sections; Section 9, Front
panel configuration (RT200), Section 11, Webpage configuration
(RT220, RT420, RT820F), and Section 12, Command configuration.
Visit www.gardasoft.com for application notes on this product. There
is also a Support page which has information on troubleshooting
problems.
1.1 Summary of features
Throughout this manual, references to the RTxxx refer to all variants in
the RTxxx range unless otherwise stated. The convention for the
product number is:
RTcd0-vv
RTcd0F-vv
where:
c Number of channels: 2, 4, 8
d
Configuration option: 0 = Pushbutton, 2 =
Ethernet, 6 = RS232
F
Option for fast pulsing. All RT8xx models are fast
pulsing.
vv Maximum pulse current in amps: 2, 20
— 5 —
To Next Page
Loading...
