Page 52
The User codes that are allocated to the system shown in Fig. 35 are:-
User No. User Type Functions Available
1 Master Set/Area Sets/Part Set/Unset
Remove Zones
Test Zones
View Log
Change Chime
Change User Codes
Change Time/Date
2 Area 1 Set/Part Set/Unset Area 1
3 Area 2 Set/Part Set/Unset Area 2
4 Area 3 Set/Part Set/Unset Area 3
Note: User codes are programmed via a master level code (factory default 5678).
Note: Part Sets will only be available if they have been programmed by the
engineer.
Note: Reset will be available on the code level programmed by the engineer.
In the event that an area does not have a code allocated to it (e.g area 1 code has
been deleted) any other area code setting the system will also set the area without a
code. This is to ensure that no areas can be left unset unintentionally.
Care should be taken by the engineer when allocating part sets so they do not overlap
into other areas.
The cleaner area acts in a different way to other areas. The cleaner area is set up
within the Zone Attributes programming sequence. Cleaner zones will then be
removed from the system when a Part/Area 0 is used. The different ways that a
cleaner code operates are:-
With system unset Cleaner code will fully set the system.
With full system set Cleaner code will unset only the cleaner zones.
With system part set 0 Cleaner code will set the remainder of the system.
With any one or more
areas set Cleaner code will set the cleaner zones.
GardTec 872
Areas, Zones & Output Types
To Next Page
Loading...
