Page 82
GardTec 872
Miscellaneous
Engineer Reset After An Alarm
If a system is programmed for engineer reset it will be necessary for the engineer to
attend the system. After the engineer has confirmed the integrity system the system
should be reset as follows:-
1) The system must be unset Unset,
by a user code.
Enter the engineer code, the display will show:-
2) Press NO, the display will show:-
3) Press YES, the display will show:-
4) Enter the engineer code again to abort the
setting, the display will show:-
5) The system is now Unset.
< < < < UN-SET > > > >
01 Jan 00: 00: 01
Do you want to . .
Use ENGNR. Mode ?
Do you want to . .
SET the System ?
Exit Now ! 1 2 3 4 5 6 7 C
All Zones On 28
To Next Page
Loading...
