Page 83
Diagnostics
The GardTec 872 control panel has several engineering diagnostic features available
via an LCD keypad. To access these diagnostics follow the steps below
1) With the display showing:-
2) Enter the Engineer code (1234 default)
The display will show:-
3) Press YES. The display will show:-
4) Press NO until the display shows:-
5) Press YES. The display will show:-
< < < < UN-SET > > > >
01 Jan 00: 00: 01
Do you want to . .
Use ENGNR. Mode ?
Program . . . . _ _ _
Zones ?
Program/ List _ _
Diagnostics / Log ?
List
Event Log ?
GardTec 872
Miscellaneous
To Next Page
Loading...
