Page 62
6P
ROGRAMMING
GardTec 872 Programming
To program the GardTec 872 the engineer must first enter the programming routine by
entering the engineer code (factory default 1234), The LCD display will then show:-
(LED displays will show
Press YES to enter into the programming routine.
LCD display will then show:-
When using the LCD keypad two methods may be used to access the various
programmable options.
Method 1
At any point during programming where three underscores are shown in the top right
hand corner of the screen, you may enter the number of the option (given in the
following section) you wish to program followed by YES. The program will then move
direct to that option.
Method 2
The programming routine is structured with a series of headers for example:-
This is the header of the Zone programming routine, all zone
programming options are accessed through this header. If you do not wish to program
anything under the zone header pressing NO will move to the next header. For
example pressing NO on the display above will move to the next header shown below:-
Details of the available headers and the options available under each header can be
found in the section GardTec 872 Program Orders.
Do you want to . .
Use ENGNR. Mode ?
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Setting Modes ?
To Next Page
Loading...
