GARDTEC 872 - Page 99

3) Enter 34 followed by YES display will show.
4) Press YES Display will show.
5) Press NO four times. Display will show.
6) Press YES. Display will show.
7) Press NO. Display will show.
8) Press YES. Display will show.
9) Press NO until the display shows.
(this mode allows you to dial the panel directly with no call back)
10) Press YES. Display will show.
(Basic modem is now set-up)
11) Press 0 (to escape). Display will show.
(Start of Comms Programming)
12) Press YES. Display will show.
(Use 0 until display shows Unset if you don’t wish
to program the Comms functions).
13) Press NO twice. Display will show.
Page 98
Digicom Type . . . .
= Mod + F / F
Test Digicom
Channels ?
Program Digicom
Functions ?
View Modem Log ?
Program Modem
Functions ?
Modem mode
= Off
Modem mode
> No Return
Double Ring
= Off
Program Comms
Functions ?
Comms = Off
Comms >On
Appendix 1
GardTec 872
872.qxd 05/11/2003 15:01 Page 98