Page 46
490X Engineer’s Reference Guide
The available options for the Quick Key are.
Off The Quick Key is disabled
Quick-Set Reduces the Exit Time after Exit has started.
Full-Set Enter user code then Quick Key
Part-Set Enter user code then Quick Key for Part 1 Set
16) Press No until the required setting is displayed
then press Yes. The display will show:-
17) Press No. The display will show:-
This option is used to program the Number of Keypads you have on the system.
It should be noted the there are no jumpers in the RKP to ident them this is done
from the program option.
18) Press Yes. The display will show:-
19) Press Yes. The display will show:-
20) Enter the Number of the keypad you wish to
program onto the system (1 to 4) then press
Yes. The display will show:-
21) Press the No & the Yes buttons together on the
selected keypad. The display will show:-
Program Keypad
Quick Key ?
Program Keypad
Number ?
Install Keypad ?
Enter Keypad # _
then +YES or -NO
Press NO + YES on
Selected Keypad
Keypad Installed
OK . . .
490X 1.qxd 11/07/2006 12:32 Page 46
To Next Page
Loading...
