Page 47
490X Engineer’s Reference Guide
Then:-
22) Repeat from Step 19 until all the RKPs have
ben installed onto the system.
23) Press 0 (zero). The display will show:-
24) Press No. The display will show:-
25) Press Yes. The display will show:-
26) Press No until the setting you require is displayed
then press Yes. The display will show:-
27) Press No. The display will show:-
28) Press Yes. The display will show:-
Note: Use of this option will require a compatible G-Tag RKP.
Default is Off, but maybe changed to On. It is intended for use with the external prox reader
(E-Reader) and monitors the antenna of the reader for being disconnected.
29) Press No until the setting you require is displayed
then press Yes. The display will show:-
30) This concludes the programming for
Keypad. Press 0 (zero) to return to:-
Or
Press 0 (zero) until the display shows:-
Program Keypad
Number ?
Program Keypad
Backlight Mode ?
Program Keypad
Backlight Mode ?
Backlight . . .
= On if EE/Key
Enter Keypad # _
then =YES or -NO
Program . . . . _ _ _
Keypad ?
01 Jan 00: 00: 01
Program Keypad
ACE/Prox ?
Prox Tamp. Detect
=Off
Program Keypad
ACE/Prox ?
490X 1.qxd 11/07/2006 12:32 Page 47
To Next Page
Loading...
