Page 49
490X Engineer’s Reference Guide
5) Press No until the required setting is displayed
then press Yes. The display will show:-
Note: If On is selected, the Vo-Comm menu will now appear in the USER
mode. Please refer to 490X User Guide (PR5598) for further
programming information.
6) Press No until the setting you require is displayed
then press Yes. The display will show:-
7) Press No. The display will show:-
8) Press No. The display will show:-
9) Press Yes. The display will show:-
With Digi Delay programmed, the alarm transmission to Central Station will be
delayed for the number of seconds programmed.
With Part Alarm programmed to Off there will be no transmission of Alarm,
Alarm B or Alarm Abort if the system is Part Set.
10) Press No twice. The display will show:-
11) Enter the number of seconds you require for
the Digi Delay in Part Set followed by Yes.
The display will show, for example:-
12) Press No until the required setting is displayed
then press Yes. The display will show:-
13) Press No. The display will show:-
Test Digicom
Channels ?
Program Digicom
Type or Test ?
Program Digicom
Delay / Part
Program Digicom
Delay / Part
Program Digicom
Channels
Digi Delay = 00s
Part - Alarm = On
Digi Delay = _ _s
Part - Alarm = On
Digi Delay = 99s
Part - Alarm > On
VoComm
=Off
490X 1.qxd 11/07/2006 12:32 Page 49
To Next Page
Loading...
