Garland XG24-JIB User Manual

Part # 4523133 Rev 4 (08/04/09) Page 9
SAFETY PRECAUTIONS
Always follow these safety precautions when operating the
Xpress Grill.
• THISGRILLMUST be operated by persons who have
been given adequate training.
• THISEQUIPMENTMUSTONLYBEOPERATEDUNDERAN
APPROVEDHOODSYSTEM.
• DONOT operate the grill without reading this operation
manual.
• DONOT operate the Xpress grill unless all service and
access panels are in place and fastened properly.
The Garland Xpress Grill is a semi-automatic cooking
appliance. The upper platen is lowered automatically,
following the manual, two-handed initiation of the cooking
cycle, and the upper platen is raised automatically upon
completion of the cooking cycle.
When two sided cooking, the area between the upper platen
and the griddle plate should be regarded as a “danger zone.”
During two sided cooking the operator must not be within
this danger zone. When used as a at grill, then this area is no
longer a danger zone, the platens do not move.
For whatever reason, be it cleaning, maintenance, or normal
operation, any exposed person must use extreme caution if
within this danger zone.
In two side cooking the upper platen remains in the lowered
position by nature of its own weight. It is not locked down. It
can be raised by lifting up on the handle on the front of the
platen.
The Xpress Grill may during its operation emit airborne noise
equivalent to a continuous A weighted sound pressure level
of 73dB(A).
WARNING:Toavoidseriouspersonalinjury:
• DONOT attempt to repair or replace any part of the
Xpress Grill unless all main power supplies to the grill
have been disconnected.
• USEEXTREMECAUTION in setting up, operating and
cleaning the Xpress Grill to avoid coming in contact
with hot grill surfaces or hot grease. Suitable protective
clothing should be worn to prevent the risk of burns.
• DONOT clean this appliance with a water jet.
• DONOT apply ICE or COLD WATER to a HOT grill surface.
• NOTE all warning labels and markings axed to the grill.
WARNING: After turning the master power switch to the
START position, the grill will go through initialization. If
the upper platens are in the lowered position they will
return to their raised upper position. This movement takes
approximately 8 seconds.
INTRODUCTION continued
Shipping Damage Claim Procedure
Please note that the Garland equipment was carefully
inspected and packed by skilled personnel before leaving
the factory. The transportation company assumes full
responsibility for safe delivery upon acceptance of the
equipment.
What to do if the equipment arrives damaged:
1. File a claim immediately regardless of the extent of
damage.
2. Besuretonote,"visiblelossordamage,"onthefreight
bill or express receipt and have the person making the
delivery sign it.
3. Concealed loss or damage: if damage is unnoticed until
the equipment is unpacked, notify the freight company
immediately, (within 15 days), and le a concealed
damage claim.

Garland XG24-JIB Specifications

General

Brand	Garland
Model	XG24-JIB
Category	Grill
Language	English