Setting CCR Setpoints
You can configure the high and low partial pressure of oxygen (PO2) setpoints for closed-circuit rebreather
(CCR) dives.
1 Hold MENU.
2 Select Dive Setup > CCR Setpoints.
3 Select an option:
• To configure the lower PO2 setpoint, select Low Setpoint.
• To configure the upper PO2 setpoint, select High Setpoint.
4 Select Mode.
5 Select an option:
• To automatically change the setpoint based on your current depth, select Auto.
NOTE: For example, if you descend through the high setpoint depth or ascend through the low setpoint
depth, the PO2 threshold switches to the high or low setpoint, respectively. Automatic setpoint depths
must be at least 6.1 m (20 ft.) apart.
• To manually change setpoints during a dive, select Manual.
NOTE: If you manually change setpoints within 1.8 m (6 ft.) of an automatic switch depth, then automatic
setpoint switching is disabled until you are more than 1.8 m (6 ft.) above or below the automatic switch
depth. This prevents unintended setpoint switching.
6 Select PO2, and enter a value.
7 If necessary, select Depth, and enter a depth value for the automatic setpoint change.
Dive Data Screens
You can press DOWN or double-tap the device to scroll through the data screens.
In the activity settings, you can reorder the default data screens, add a dive stopwatch, and add custom data
screens (Customizing the Data Screens, page 99). You can customize the data fields on some of the data
screens.
10 Diving
To Next Page
Loading...
Need help?
General
