28
Notice
To run programming via trigger and re selector, your
AEG must have a physical 3-stage re selector.
Turning on the programming mode*
1. Switch re selector position to SEMI
2. Fire a shot or burst
3. Keep the trigger pulled for 7 seconds
– until you hear a vibration and see
dark blue light in the trigger hole
* Not possible if Auto mode is assigned to SEMI position.
SEMI POSITION
FUNCTION WITH CORRESPONDING NUMBER OF VIBRATIONS AND LED COLOR
1 2 3 4 5
Fire mode Burst mode
Battery
protection
Active
brake
Advanced*
AUTO POSITION
OPTION WITH CORRESPONDING NUMBER OF VIBRATIONS AND LED COLOR
1 2 3 4 5 1 2 3 4 5 1 2 3 4 1 2 3 1 2 3 4
SAFE-SEMI-AUTO
SAFE-BINARY-AUTO
SAFE-SEMI-SEMI
SAFE-SEMI-BURST
GCS setting**
3 x Full
3 x Interruptible
5 x Full
5 x Interruptible
GCS setting**
O
LiPo
LiPo 3.2 V warning
GCS setting**
Auto
O
GCS setting**
DTC
Clear DTC
Restore default settings
Restore factory settings
* To evoke options of Advanced function, hold the trigger down for more than 3 seconds.
** GCS setting is a setting previously de ned in GCS application, whose value is not available for selection
in this programming mode. Once you change such setting to a di erent option during programming via
trigger and then exit this programming mode, it is no longer possible to set that setting from this level
(it can be still speci ed via GCS).
To Next Page
Loading...
Need help?
General
