CHAPTER 5: Upgrading Your Computer
60
www.gateway.com
15
In the BIOS Setup utility, restore any
settings that you wrote down in Step 3.
16 Save all your settings and exit the BIOS
Setup utility.
Adding or replacing an optical disc
drive
To add or replace an optical disc drive:
1 Remove the side panel by following the
instructions in “Removing the side panel”
on page 51.
2 Remove the front bezel by following the
instructions in “Removing the front bezel”
on page 53.
Important
The color and
shape of your
replacement
drive's front cover
may vary from
your original
drive.
3 If you are installing a new drive, slide the
drive release latch toward the back of the
computer, then go to Step 7.
- OR -
If you are replacing an existing drive,
disconnect the cables from the drive,
noting their locations and orientation. You
will reconnect the cables after you install
the new drive. (CD/DVD drive shown.)
8511781.book Page 60 Tuesday, October 10, 2006 4:41 PM
To Next Page
Loading...
