www.gateway.com
41
5 Remove the jumper from its normal position (bridging
pins 1-2), then place it in the maintenance boot position
(bridging pins 2-3).
6 Reconnect the power cord.
7 Turn on your. The BIOS Setup utility opens.
8 Press the arrow keys to select the Performance tab.
Press the arrow keys to highlight Set Processor
Multiplier, then press E
NTER.
9 Press the - (minus) or + (plus) key repeatedly to adjust
the multiplier, then press ENTER.
10 Press F10 to exit BIOS, then press Y to accept the
changes. The screen displays the message “Turn off
power and reinstall the jumper in Normal mode
position.”
11 Turn off the computer.
12 Disconnect the power cord and follow all anti-static
precautions.
13 Return the jumper to the Normal position (bridging
pins 1-2).
14 Close the computer case.
15 Reconnect the power cord.
16 Turn the computer on. If the jumper is in the correct
position and the multiplier is low enough, your
computer should start normally.
Setting up multiple monitors
To set up multiple monitors, see the “Customizing” chapter in
your online User Guide.
8511858.book Page 41 Monday, December 18, 2006 10:51 AM
To Next Page
Loading...
Need help?
General
