CHAPTER 1: Upgrading Your Computer
56
Adding or replacing a
hard drive
To add or replace a hard drive:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 45.
2 If you are adding a new drive, slide the drive release
latch toward you, then go to Step 5.
- OR -
If you are replacing an existing drive, go to the next
step.
3 Disconnect the drive cables, noting their locations and
orientation. (You will reconnect the cables after you
install the new drive.)
8511858.book Page 56 Monday, December 18, 2006 10:51 AM
To Next Page
Loading...
