CHAPTER 1: Upgrading Your Computer
64
Replacing the heat sink and
processor
To replace the heat sink and processor:
1 Remove the side panel by following the instructions in
“Removing the side panel” on page 45.
2 For more stability, place your computer on its side. To
avoid scratching the case, place it on a towel or other
non-abrasive surface.
3 Remove the fan cover by squeezing the top (1) and
bottom (1), then pulling the cover (2) out.
Tools
You need a Phillips screwdriver to replace the heat sink.
1
1
2
8511858.book Page 64 Monday, December 18, 2006 10:51 AM
To Next Page
Loading...
