CHAPTER 1: Upgrading Your Computer
60
4 Remove the fan mount by pressing in on the flat area (1)
near the front, then rotating the fan mount (2) back.
5 Slide the old fan out of the fan mount.
6 Slide the new fan into the fan mount.
7 Insert the tabs on the rear of the fan mount into the
slots provided, then rotate the mount into place. The
mount should lock into place.
8 Reconnect the fan cable to the system board.
9 Replace the fan cover.
10 Replace the side panel by following the instructions in
“Replacing the side panel” on page 48.
Caution
Be careful not to catch the wires connecting the power button
to the system board when rotating the fan mount. A notch has been
provided for routing these wires.
1
2
8511858.book Page 60 Monday, December 18, 2006 10:51 AM
To Next Page
Loading...
