GCC Technologies Expert 52 - Page 15

Expert 52 User Manual
Installation
2-8
Step 4
Insert the blade holder into tool carriage. Please note the outward ring of the holder must put
into the grooves of carriage firmly (see Figure 2-11), fasten the case (Figure 2-12).
Figure 2-11 Figure 2-12
Step 5
Use the reversing steps to remove the blade holder.
Step 6
Eject the blade: Push “Blade eject pin” to eject blade when the blade needs to be replaced.
Caution
The blade will lose its sharpness after a period of usage, the cutting quality might
be affected. By increasing the cutting force, it might do the trick. How
ever, once
the blade is worn out and no longer provides a reliable cutting, you should replace
a new one. The blade is consumable and must be replaced as often as necessary
to maintain the cutting quality. The quality of the blade deeply affects cutting
qu
ality. So be sure to use a high quality blade to ensure good cutting results.
Tips - When to replace a new blade:
 If the blade is broken, you have to replace a new one.
 If cutting quality is not as good as usual, you may need to replace a new
one.
 If the material cannot be cut through by higher cutting
force, you may need
to replace a new one.