Step 1 Move the carriage to a new position.
Step 2 Press the ORIGIN SET button to reset origin.
3.1.3 Cut Test
Step 1 After sizing, press the ON/OFF LINE button to set as off-line mode.
Step 2 Move the carriage to a preferred position.
Step 3 Press CUT TEST button to perform.
3.1.4 Repeat
Step 1 Press the ON/OFF LINE button to set as off-line mode.
Step 2 Press the REPEAT button to perform re-plot function starting at the position where
the carriage locates. It is also available to move carriage to a preferred position,
re-set origin, and then perform this function.
3.2 VLCD
“VLCD” is a computer program to help modify parameters of cutting functions.
3.2.1 Installation
Step 1 Copy the VLCD.exe file in the Accessories folder of the Expert 52 Installation CD
onto your local drive to finish installation.
Step 2 Launch VLCD by double-click on the icon.
Note:
Make sure the machine is in off-line mode to enable this function.
It’s recommended to keep performing this function until the cutting
quality meets your demand before executing the cutting job.
Note:
Make sure the machine is in off-line mode to enable this function.
Note:
Make sure the machine is in on-line mode to enable this program.
There is media in the machine.
To Next Page
Loading...
