Error 3 Check the media, drum or X-motor (Drum driven motor)
This message indicates that there might be a problem on the X-axis.
Please check that the drums are working normally and see that the media is well loaded. Then turn on
the power and reboot the cutting plotter.
Error 4 Check the media, or Y motor (carriage driven motor)
This message indicates that there might be an obstruction to the carriage relating to a problem on the
Y-axis.
Please clear the obstruction and check that the carriage can move smoothly. Then turn on the power
and reboot the cutting plotter.
To Next Page
Loading...
