Step 11 Sure Cuts A Lot is ready to use.
2.3.2 Manually Activate Software
If the computer connected to i-Craft
TM
cutter doesn’t have internet connection
to accomplish above software activation process, you can use “Activate
manually” function alternatively to enter the “Activation Code” to start the
usage of Sure Cuts A Lot. Meanwhile, you need to find another computer that
has internet access to obtain the “Activation Code” in advance following below
instructions.
Note
If you use a trial version to output graphics, meaning you do not enter the
software key to activate the Sure Cuts A Lot mentioned above, there will
be two extra lines cut through the design, therefore, make sure the Sure
Cuts A Lot software is activated before implementing cutting jobs.
To Next Page
Loading...
