5.3 Menu function
5.3.1 Media Menu
To set or modify tool speed at horizontal
moving.
To set or modify the value of pressure that
is being cut; make sure the material can be
cut through.
To generate an overcut to facilitate
weeding.
To set or modify cutting quality.
While cutting small letter, set as “Fine”.
While cutting in high speed, set as “Draft”.
Please note that if you set at a high cutting
speed, it may lower its cutting quality.
To select the corresponding tool that is
installed in carriage.
Regular blade,
Advanced blade,
Pen
To perform a cutting test at present settings
To select the file saved in the SD card.
To perform the same cutting job at current
position
To duplicate job next to the 1
st
one
To Next Page
Loading...
