Note:
1. To save your materials, in addition to amending object margins, you can
also adjust the length of the registration marks (5mm minimum) when you
apply 4-Point Positioning (see table 1 for suggestions based on different
material sizes). The smaller the size is, the smaller the distance between
the object and the registration marks is (see the figures below).
Table 1
*25mm is the suggested value for the registration mark length
2. The size of the registration marks would affect the accuracy of registration
mark detection so please make sure the amount you enter is reasonable.
3. If you change the paper size, you will have to reset the registration marks
otherwise the previous setting will be applied.
To Next Page
Loading...
