GCC Technologies i-Craft - Page 72

71
Multiple Copies
It is suggested to select “Multiple Copies” when you would like to make several
copies of one image on your material to increase cutting accuracy.
Multiple Copies
 No. of X Copies: The numbers of copies on
X axis
 No. of Y Copies: The numbers of copies on
Y axis
 Range: 1~50. (The more copies you
make, the more time is needed for data
transmission.)
 Numbers of X Copies * Numbers of Y
Copies = The total amount of image copies
 Copies with outline：To show outlines of
image graphics
The system will create the as shown in the picture below.
X axis
Y axis
Figure A3-11
Figure A3-12