GE Grid Solutions MDS Master Station - CLI Configuration Examples

86 MDS™ Master Station MDS 05-6399A01, Rev. F
station so that RSSI can be checked. While in Test Mode, a radio will not operate normally and
does not communicate with the narrowband network.
To enter or exit Test Mode, select the desired test state from the State drop-down box and click
Perform Action.
 Time – The time, in minutes, to remain in test mode before automatically resuming normal
operation. We recommend that you remain in test mode 10 minutes or less.
 State -
- Receive – Enter Receive mode to check the RSSI of a received signal.
- Keyed – Key the transmitter. To prevent damage to the radio, the unit will stop keying after one
minute and automatically transition to the Receive state.
- Stop – Stop all test operations and exit test mode.
Test Values
 Test Mode Time – The length of time test mode has been running.
 Test State – Receive, Keyed, Stop. The current test state.
 Test RSSI (Receive Mode only) – The current signal RSSI.
CLI Configuration Examples
AP Mode
On the next page, the example will display how to configure the LN module as an access point
with the network name of ‘MyNetwork’ and default settings. For this example we assume a
transmit frequency of 451.4 MHz and a receive frequency of 456.4 MHz. Your own LN
frequencies must be set according to your user license.
% set interfaces interface lnms ln-config device-mode access-point network-name MyNetwork
tx-frequency 451.4 rx-frequency 456.4
% show interfaces interface l nms ln-config | details
radio-mode standard;
members [ ln-1/0/0 ln-2/0/0 ];
device-mode access-point;
network-name MyNetwork;
data-compression lzo;
header-compression true;
power 40;
tx-frequency 451.4;
rx-frequency 456.4;
channel 12.5KHz-9.6ksps;
modulation automatic;
fec false;
security {
security-mode none;
encryption none;
}
advanced-config {
data-retries 3;
packet-ttl 600;
remote-age-time 600;
endpoint-age-time 300;
allow-retransmit true;