9–10 EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL
ANALOG TRANSDUCER SIGNAL OUTPUT MODULES CHAPTER 9: EXTERNAL I/O MODULES
9.5.2 Normal Mode
Normal Mode is the same for the 0-1mA and the 4-20mA Analog Output Modules except
for the number of processes performed by the modules.
Both devices:
1. Accept new values through communication.
2. Output current loops scaled from previously accepted values.
The 0-1mA module includes one more process in its Normal Mode:
3. Read and average the A/D and adjust values for Process 2 above.
The device will operate with the following default parameters:
Address: 247 (F7H)
Baud Rate: 57600 Baud
Transmit Delay Time: 20 msec
Normal Operation is prevented by a number of occurrences. See Section 9.4 for details.
To Next Page
Loading...