GE Grid Solutions Multilin 9450 - 3.2 Mounting the EPM P40 NPLUS LED External Display

3–4 EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL
MOUNTING THE EPM P40N
PLUS
LED EXTERNAL DISPLAY CHAPTER 3: HARDWARE INSTALLATION
3.2 Mounting the EPM P40N
PLUS
LED External Display
The EPM 9450/9650 LED display (model number PL9000-P40NPLUS0) mounts using a
standard ANSI C39.1 drill plan.
Secure the four mounting studs to the back of the panel with the supplied nuts.
Six feet of RS485 communication/power cable harness is supplied. Allow for at least a
1.25-inch (3.17cm) diameter hole in the back for the cable harness. See Chapter 5 for
communication and power supply details.
The cable harness brings power to the display from the EPM 9450/9650 meter, which
supplies 15–20V DC. The P40N
PLUS
can draw up to 500mA in display test mode.
Figure 3-3: ANSI C39.1 Drill Plan for P40N
PLUS
Display
NOTE
Note
The P40N shown below is a legacy product, and not intended for new applications.
Figure 3-4: Legacy P40N Dimensions
P40N Front Dimensions
4.38” Sq.
(11.12 cm)
1.438” Sq.
(3.65 cm)
.75”
(1.91
cm)
P40N Side Dimensions