6–18 EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL
USING THE EPM P40NPLUS LED EXTERNAL DISPLAY CHAPTER 6: USING THE EXTERNAL DISPLAYS
6.3.5 EPM P40N
PLUS
Information Mode
Use the Mode button to access the EPM Information mode from other modes. Use the Up/
Down arrows to navigate from group to group within this mode.
Group 1: Device Time
Meter Time
Group 2: Communication Settings (Use the Left/Right arrows to access the following
readings, in order.)
• Communication Settings Port 1: Baud/Addr/Protocol
• Communication Settings Port 2: Baud/Addr/Protocol
• Communication Settings Port 3: Baud/Addr/Protocol
• Communication Settings Port 4: Baud/Addr/Protocol
Group 3: PT/CT Ratios (Use the Left/Right arrows to access the following readings, in
order.)
• PT Ratio
• CT Ratio
Group 4: External Display Units
Primary/Secondary
Select either Primary or Secondary units for the External Display using the GE
Communicator software (see the GE Communicator Instruction Manual).
• When Primary is selected, the Display shows all readings in Primary units based on
the user programmed PT and CT Ratios.
• When Secondary is selected, the Display shows all readings in Secondary units.
Group 5: Firmware Versions and Serial Numbers (Use the Left/Right arrows to access the
following readings, in order.)
• Run Time External Display/Run Time DSP/RunTime Comm
• Boot External Display/Boot DSP/Boot Comm
• Serial Number External Display; Serial Number EPM Monitor
To Next Page
Loading...