CHAPTER 6: USING THE EXTERNAL DISPLAYS USING THE EPM P40NPLUS LED EXTERNAL DISPLAY
EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL 6–15
• Use the UP/DOWN arrows to scroll from group to group within each mode.
• Use the LEFT/RIGHT arrows to scroll from reading to reading within each group.
Use the GE Communicator software to Flash Update the P40N
PLUS
external display. Refer
to the GE Communicator Instruction Manual for instructions.
6.3.4 EPM P40N
PLUS
Dynamic Readings Mode
The External Display puts itself in the Dynamic Readings Mode upon power-up. Use the
Mode button to access the Dynamic Readings from other Modes. Use the Up/Down arrows
to navigate from Group to Group within this Mode.
Group 1: Phase to Neutral Voltages (Use the Left/Right arrows to access the following
readings, in order.)
•Volts AN/BN/CN
• Maximum Volts AN/BN/CN
• Minimum Volts AN/BN/CN
•Volts AN/BN/CN %THD
• Volts AN/BN/CN Maximum %THD
•Volts AN/BN/CN Minimum %THD
Group 2: Phase to Phase Voltages (Use the Left/Right arrows to access the following
readings, in order.)
• Volts AB/BC/CA
• Minimum Volts AB/BC/CA
• Maximum Volts AB/BC/CA
Group 3: Current (Use the Left/Right arrows to access the following readings, in order.)
• Current A/B/C
•Maximum Current
• Minimum Current
• Current %THD
• Current Maximum %THD
• Current Minimum %THD
• Current Calculated N/Measured N
• Maximum Current Calculated N/Measured N
Group 4: Watt/VAR (Use the Left/Right arrows to access the following readings, in order.)
•kWatt/kVAR
• Maximum +kWatt/+kVAR/CoIn kVAR
• Maximum -kWatt/-kVAR/CoIn kVAR
• Block (Fixed) Window Average Maximum +kWatt/+kVAR/CoIn kVAR
• Predictive Rolling (Sliding) Window Maximum +kWatt/+kVAR/CoIn kVAR
Group 5:VA/PF/Frequency (Use the Left/Right arrows to access the following readings, in
order.)
•kVA/PF lag/Hz
To Next Page
Loading...