GE Grid Solutions Multilin 9450 - 6.3 Using the EPM P40 NPLUS LED External Display

CHAPTER 6: USING THE EXTERNAL DISPLAYS USING THE EPM P40NPLUS LED EXTERNAL DISPLAY
EPM 9450/9650 ADVANCED POWER QUALITY METERING SYSTEM – INSTRUCTION MANUAL 6–11
6.3 Using the EPM P40N
PLUS
LED External Display
6.3.1 Using the EPM P40N
PLUS
USB port
The EPM P40N
PLUS
LED external display has a USB port on the front for direct data
downloads. You can connect to the USB port with GE Communicator to poll and configure
the meter attached to the display. To use the USB, follow these instructions:
1. Use the EPM Series Product CD, shipped with your meter, to install the GE
Communicator software and the driver for the P40N
PLUS
USB port.
• Insert the CD into your PC's CD drive. The screen shown below opens in
your Browser.
• To install GE Communicator, click the Install Software button and click Run
on the screen that opens.
• Click on the USB Driver button and click Run on the screen that opens.
The P40N
PLUS
driver is installed.