CHAPTER 6: ACTUAL VALUES TARGET AND FLASH MESSAGES
745 TRANSFORMER PROTECTION SYSTEM – INSTRUCTION MANUAL 6–29
PRESS [ENTER] TO
ADD AS DEFAULT
This flash message is displayed for 5 seconds in
response to pressing the decimal key followed by
ENTER while displaying any setpoint or actual value
message except the
S1 745 SETUP DEFAULT
MESSAGES
SELECTED DEFAULTS setpoint. Pressing
ENTER again while this message is displayed adds the
setpoint or actual value message to the default list.
PRESS [ENTER] TO
BEGIN TEXT EDIT
This flash message is displayed in response to pressing
the VALUE keys while on a setpoint message with a
text entry value. The ENTER key must first be pressed
to begin editing.
PRESS [ENTER] TO
REMOVE MESSAGE
This flash message is displayed for 5 seconds in
response to pressing the decimal key followed by
ENTER while displaying one of the selected default
messages in the
S1 745 SETUP DEFAULT MESSAGES
SELECTED DEFAULTS menu. Pressing ENTER again
while this message is displayed removes the default
message.
PRESSED KEY
IS INVALID HERE
This flash message is displayed in response to any
pressed key that has no meaning in the current
context.
RESETTING LATCHED
CONDITIONS
This flash message is displayed in response to pressing
RESET when the relay is in local mode. All active
targets for which the activating condition is no longer
present will be cleared.
SETPOINT ACCESS
DENIED (PASSCODE)
This flash message is displayed in response to pressing
ENTER while on any setpoint message. Setpoint access
is restricted because the programmed passcode has
not been entered to allow access.
SETPOINT ACCESS
DENIED (SWITCH)
This flash message is displayed in response to pressing
ENTER while on any setpoint message. Setpoint access
is restricted because the setpoint access terminals
have not been connected.
SETPOINT ACCESS
IS NOW ALLOWED
This flash message is displayed in response to entering
the programmed passcode at the
S1 745 SETUP
PASSCODE
ALLOW SETPOINT WRITE ACCESS
setpoint. The command to allow write access to
setpoints has been successfully executed and
setpoints can be changed and entered.
SETPOINT ACCESS
IS NOW RESTRICTED
This flash message is displayed in response to
correctly entering the programmed passcode at
S1
745 SETUP
PASSCODE ALLOW SETPOINT WRITE
ACCESS
. The command to restrict access to setpoints
has been successfully executed and setpoints cannot
be changed.
To Next Page
Loading...
