GE AED Pro - Section 4: Data Management; Overview; Recording the Rescue Data; Review the Rescue Data

Section 4: Data Management
2023486-201 Rev C © 2007 General Electric Company Page 31 of 53
SECTION 4: DATA MANAGEMENT
OVERVIEW
The Responder AED Pro is designed for ease of data management and review. The data stored in internal memory can
be displayed on the PC screen using the RescueLink software.
TOPIC
PAGE #
RECORDING THE RESCUE DATA 31
REVIEW THE RESCUE DATA 31
RESCUELINK OVERVIEW 32
RESCUELINK INSTALLATION INSTRUCTIONS 33
MULTIPLE RESCUE FUNCTIONALITY 33
RECORDING THE RESCUE DATA
RECORDING DATA IN INTERNAL MEMORY
The AED Pro automatically stores up to 60 minutes of the latest rescue data.
REVIEWING THE RESCUE DATA
RETRIEVING DATA FROM MEMORY
1. Open the AED Pro lid and remove pads from socket.
2. Point IR port on the AED Pro to IR adapter attached to the PC.
3. Run the RescueLink software program on the PC and select G3 Pro.
4. Select Communications, Get Rescue Data. On the RescueLink software program.
5. The voice prompt will say “COMMUNICATIONS MODE”.
6. Select Internal Memory of AED then select OK.
7. Reinstall pads and close lid.
Note: The approved IR adapter is ACT-IR220LN115 from ACTiSYS Corp. Please contact
customer service to order.