Page 36 of 53 Copyright © 2007, General Electric Company 2023486-201 Rev C
INDICATOR TROUBLESHOOTING TABLE
The following is a troubleshooting table for the AED Pro indicators.
VIEW SYMPTOM SOLUTION
Red SERVICE indicator (LED) is
indicated on the screen.
Red PADS indicator (LED) is indicated
on the screen.
The SMARTGAUGE BATTERY
indicator shows one bar of battery life
that is red and flashing.
STATUS INDICATOR is RED, and no
other indicators on the diagnostic panel
are lit.
Maintenance by authorized service personnel
is required. Call Customer Service or your
local distributor.
Connect the pads or replace with a new pair.
The battery is low. Replace with a new
battery.
The battery power is completely depleted.
Replace with a new battery. If STATUS
INDICATOR remains RED, refer to the
Responder AED Pro for maintenance.
Call Customer Service or your local
distributor.
SCHEDULED MAINTENANCE
DAILY MAINTENANCE
Check the STATUS INDICATOR to ensure that it is GREEN. When the indicator is GREEN, the
Responder AED Pro is ready for a rescue. If the indicator is RED, refer to the Troubleshooting Table in this
chapter.
MONTHLY MAINTENANCE
1. Open the AED Pro lid.
2. Wait for the AED Pro to indicate status
Observe the change of the STATUS INDICATOR to RED. After approximately 5 seconds, verify that the
STATUS INDICATOR returns to GREEN.
3. Check the expiration date on the pads.
4. Listen for the voice prompts.
5. Close the lid and confirm that STATUS INDICATOR remains GREEN.
To Next Page
Loading...
