GE Amersham Imager 680 - Network Setup

4.4.1 Network setup
Virus protection
The technical solution for Amersham Imager 680 protects it from virus transfer from in-
fected USB flash drives. Each restart of the instrument resets the software to its original
installation.
If you, for any reason, suspect that the instrument has been infected by a
computer virus, restart the instrument as soon as possible.
Note:
Network connection options
NOTICE
Do not connect telephone lines to the Ethernet port.
Only the IEC 60950-I/VL 60950-1 standard non-shielded cables are
appropriate for connection to this connector.
Connection to a network enables the instrument to access files from, and to save files
to, a network location.
There are two options for network setup:
1
DHCP
2
Static IP
If a DHCP network is used the IP address will be assigned automatically by
the DHCP server. If a Static IP network is used the network details have to be
entered manually.
Note:
90 Amersham Imager 680 Operating Instructions 29271308 AB
4 Installation
4.4 Network
4.4.1 Network setup