Chapter 4: Testing and troubleshooting
Concord 4 Installation Manual 97
5. Contact the central monitoring station when you are finished testing.
Table 17 below describes the system alarm sounds you should hear for each alarm
event.
Table 17: System alarm sounds
Alarm type Alarm sound
Fire Repeating series of three beeps
Police/Intrusion Continuous tone
Auxiliary Rapid beeps
Light control
Test all lights plugged into X10 lamp modules to verify house code and light number
settings.
To test light control:
1. Press 0, 0 repeatedly to turn all lights on and off together.
2. Press 0, 1 repeatedly to turn light 1 on and off.
3. Repeat step 2 for remaining lights (0 + 2 for light 2, 0 + 3 for light 3, etc.).
4. Arm the system to away. All lights plugged into modules set to unit 1 (or set as
entry lights) should turn on and stay on for 5 minutes. All lights plugged into
modules set to unit 2 should blink three times to indicate the arming level.
Remaining lights should not be affected.
5. Disarm the system. If unit 1 (or entry) lights were on for an entry or alarm, they will
turn off in 5 minutes. Unit 2 lights should blink once to indicate the system is off.
Remaining lights should not be affected.
6. All lights should turn on and remain on during fire and auxiliary/medical alarms.
All lights should flash during a police or intrusion alarm.
Energy saver module (ESM)
Test the energy saver module to verify it overrides the thermostat.
Note: The system must have high- and low-temperature limits set to test the energy
saver module.
To Next Page
Loading...
Need help?
General
