Chapter 5. Using the Optional Data Recorder
50 DM5E Operating Manual
5.2.2 Erasing a Data Recorder File
1. Press again to launch the File Display mode.
2. If necessary, press below FILES to display a list of the stored files.
3. Press or to select the stored file you wish to erase, then press and hold below ERASE.
IMPORTANT: Once erased, the Data Recorder file and any stored thickness measurements cannot be retrieved.
5.3 Recording Thickness Measurements in Data Recorder Files
The Data Recorder must be enabled (turned ON) via the CONFIGURATION display. Once the Data Recorder is turned on, the contents of
the active Data Recorder file are displayed in the File Navigation Grid shown in Figure 20 on page 48.
To store a thickness reading in the selected file position, press below SEND. Remember that the units of the thickness value and the
number of decimal places to which the thickness is recorded are determined by the UNITS and RESOLUTION settings as described in
Section 3.2 on page 21.
To Next Page
Loading...
