GE DM5E - Storing Minimum of B-Scan in Data Recorder Files; Navigating through Data Recorder Files

Chapter 5. Using the Optional Data Recorder
DM5E Operating Manual 51
5.3.1 Storing Minimum of B-Scan in Data Recorder Files
When in B-Scan mode, the minimum value is stored in the active position of the Data Recorder by pressing below SEND.
5.3.2 Navigating Through Data Recorder Files
When the Data Recorder is turned ON, the contents of the active Data Recorder file are displayed in the File Navigation Grid shown in
Figure 20 on page 48. After the navigation grid is activated, , , and can be used to select any file position. A heavier grid
box appears around the selected file position. Once a file position has been selected:
• The current thickness reading can be sent to an EMPTY file position.
• A measurement value can be stored by pressing below SEND.
• A previously-stored value can be overwritten by pressing below SEND.